Title

Analysis of Temperature Field, Heat and Fluid Flow of Two-Phase Zone Continuous Casting Cu–Sn Alloy Wire

Journal title

Archives of Foundry Engineering

Yearbook

2016

Issue

No 1

Authors

Luo, J. ; Liu, X. ; Wang, X.

Keywords

Two-phase zone continuous casting ; Cu–Sn alloy ; Numerical simulation ; Temperature field ; Heat flow ; fluid flow

Divisions of PAS

Nauki Techniczne

Publisher

The Katowice Branch of the Polish Academy of Sciences

Date

2016

Type

Artykuły / Articles

Identifier

DOI: 10.1515/afe-2015-0099 ; eISSN 2299-2944

Source

Archives of Foundry Engineering; 2016; No 1

References

Li (1997), Numerical simulation of flow and temperature evolution during the initial phase of steady - state solidification Processing, Journal of Materials Technology, 71. ; Şahin (2006), Determination of unidirectional heat transfer coefficient during unsteady - state solidification at metal casting chill interface and, Energy Conversion Management, 47. ; Martorano (2000), Heat transfer coefficient at the metal mould interface in the unidirectional solidification of Cu Sn alloys of Heat and Mass Transfer, International Journal, 8, 43. ; Guan (2013), Effect of the casting temperature on temperature field and microstructure of alloy during an innovative continuous semisolid rolling process with a vibrating sloping plate device of Manufacturing, The International Journal Advanced Technology, 67. ; Zuo (2008), Study on the sump and temperature field during low frequency electromagnetic casting a superhigh strength Al Zn Mg Cu alloy Processing, Journal of Materials Technology, 197. ; Qu (2012), Influence of temperature field on the microstructure of low carbon microalloyed ferrite bainite dual - phase steel during heat treatment and, Materials Science Engineering, 536. ; Janik (2004), Modelling of three - dimensional temperature field inside the mould during continuous casting of steel Processing, Journal of Materials Technology, 157. ; Zhao (2010), Microstructure development of different orientated nickel - base single crystal superalloy in directional solidification, Materials Characterization, 61. ; Liu (2013), Columnar grains - covered small grains Cu - Sn alloy prepared by two - phase zone continuous casting in : Materials International, Progress Natural Science, 23, 94, doi.org/10.1016/j.pnsc.2013.01.014 ; Turchin (2005), Effect of melt flow on macro - and microstructure evolution during solidification of an Cu alloy and, Materials Science Engineering, 4, 413. ; Lu (2014), Simulation study on the centrifugal casting wet - type cylinder liner based on ProCAST Thermal, Applied Engineering, 73. ; Eck (2005), Measurement and simulation of temperature and velocity fields during the cooling of water in a die casting model and, Materials Science Engineering, 413. ; Kato (1978), Growth structures of wt pct Cu alloys with dendrite growth directions differing from the heat flow direction, Journal Metallurgical Transactions, 4, 9.